Whiteside Ultimate Pattern – Trim Bit

Intro A Shop Talk showing examples on using the Whiteside Ultimate Sprial/Trim router bits.  This video will show 5 examples of how I have used these two very amazing router bits. I have two of these Bits. Whiteside Model UDP9112 Ultimate Spiral Pattern Bit Whiteside Model UDFT9112 Spiral Flush Trim This video will show 5 […]

Sewing Cutting Table – Part 5 – Base build

Sewing Cutting Table Summary I have created a project page for the Cutting Sewing Table.   Click on the link in the heading above. Base Assembly In this shop session, I assembled the two shelf units and the drawer unit with clamps.  From this I was able to get the dimensions of the base that […]

Cabinet Trim using Hand Planes and Pocket holes

Intro The Sewing  Cutting Table project continues.   The cabinets are assembled and need some trim pieces.  The video will show how I created and attached the trim to the cabinet pieces.  The plywood trim pieces are attached using at Grex P635 pin nailer. The Video Tool Links Lie-Nielsen 5 1/2 Jack Plane      […]

Pocket Hole Cabinet Assembly

Intro I have built many pocket hole cabinets for my shop and other cabinet needs. Along the way I have delveloped some tips and techniques that you might find useful. This is my 3rd video. This was completed using bucket pod 1 & 2 which proved to be successful in their ease of setup in […]

Bucket Pod 2 – Video Blog

Continuing my obsession with Video in the workshop,  I needed a second bucket pod type support for my new “B” camera a Canon VIXIA HF R500 Camcorder.   There were some problems with the first Bucket Pod.  The top of the stand has some “wobble” but works just fine once you start shooting.   Also […]

Cyclone Dust Collection FULL

Well, it had to happen.  I do not have any routine inspection of my cyclone dust collection to determine if it is FULL.  BAD Mistake !! I built the entire Workbench TWO Project and then some without ever checking the cyclone. A woodworker friend came over on Saturday to use my Domino for a project. […]

Sewing Rooming Cutting Table – Part 2

Next step is the drawer cabinet.  The design ( below ) is to have two shelf units and the drawer unit. NOTE:  All parts of these cabinets are 3/4″ Home Depot Sande Ply. This process follows steps that I have developed over several projects. Determine the size of the box Decide drawer configuration with drawer […]