Quilting Design Wall

Introduction

This project was a request from my wife to make her a “pin up” board on the wall in her sewing room.   The purpose of this is to allow a quilter to put together quilt square ( parts ) to be able to see what they look like on the Design Wall.   As I learned at the very end of the project this is just like the felt stick on boards we had 55 years ago.

The main two ingredients for this project are 3/4″ hard insulation board and quilt backing which is very much like felt.  The complete specifications for these are below.

The Video – Quilting Design Wall

 

Products, Tools and Supplies

         

 

Pica-Dry Pencil with Red filler

festool-pica-dry

 

Facebooktwittergoogle_plusredditpinterestlinkedintumblrmail

Comments

  1. Matt Robin says

    Been there done that a few years back.I used Homasote covered in a flannel.Fabric will stick to it or pin to it.

Leave a Reply

Your email address will not be published. Required fields are marked *