A router table is a standard necessity in a powered woodworking shop. I gathered parts for mine for at least two years. Found a micro adjuster on eBay. Got a good deal on a Rockler fence. Of course I was sold on the Norm Abrams design. I found a used Hitachi MV 12, 3hp router. This is a standard for router tables.
I started with a top. Two layers of 3/4″ MDF glued. I got luck and the glued up top ended up FLAT! The pictures tell the rest of the story.
![Share on Facebook Facebook](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/facebook.png)
![Share on Twitter twitter](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/twitter.png)
![Share on Reddit reddit](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/reddit.png)
![Pin it with Pinterest pinterest](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/pinterest.png)
![Share on Linkedin linkedin](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/linkedin.png)
![Share on tumblr tumblr](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/tumblr.png)
![Share by email mail](https://www.mysaw.com/wp-content/plugins/social-media-feather/synved-social/image/social/regular/64x64/mail.png)